产品中心
新闻动态 当前位置:首页>新闻动态>新闻动态

太阳能维修的方法

网址:bdkongtiao.oy56.cn  2021-07-15  作者:admin    阅读:

步骤一、检查控制面板
Step 1. Check the control panel
控制面板显示太阳能热水器没有水,那么原因可能是热水可能空了,当然这个信息也不是绝对可信的,传感器故障也会导致控制面板传送错误的信号。看起来是没水,实际有水。
The control panel shows that there is no water in the solar water heater, so the reason may be that the hot water may be empty. Of course, this information is not absolutely credible, and the sensor failure will also cause the control panel to send the wrong signal. It looks like there's no water. There's water.
步骤二、检查电磁阀
Step 2: check the solenoid valve
太阳能热水器放不了水可能是电磁阀故障,可以通过检查电磁阀,得到一个确切的答案。即按上水,打开花洒调整到热水的方向,看看会不会出水。如果坏了,可以花二三十块钱买两根十二伏直流电线。
Solar water heater can not discharge water may be the solenoid valve failure, you can check the solenoid valve, get an exact answer. That is, press the water, open the shower, adjust to the direction of hot water, and see if there will be water. If it doesn't work, you can buy two 12 volt DC wires for 20 or 30 yuan.
步骤三、检查窗外环境
Step 3: check the environment outside the window
在上水之后太阳能热水器还是无法防水那么很有可能是水漏了,所以要求看看窗外的情形判断一下,如果不是那么就是电磁阀的原由。
After the water supply, the solar water heater still can't be waterproof, so it's likely that the water is leaking, so it's required to look out of the window to judge, if not, then it's the reason for the solenoid valve.
步骤四、太阳能热水器设计
Step 4, solar water heater design
如果太阳能热水器采用的是老式的,那么在使用的过程中会因为没有控制仪,从而浮子坏了导致不上水。
If the solar water heater is old-fashioned, there will be no controller in the process of use, so the float is broken, resulting in no water supply.

返回新闻

网站出租电话
13313028229